Sorozat:
Power Mate - Model D
Power Mate - Model F
Kézikönyv-azonosító: B-62094E/04
További információ:
Operator's Manual o.: 47-48
| Kód | Csoport | Kezdeti G-kódok | Funkció |
|---|---|---|---|
| G00 | 01 | + | Positioning |
| G01 | 01 | + | Linear interpolation |
| G02 | 01 | Circular interpolation (clockwise) | |
| G03 | 01 | Circular interpolation (counterclockwise) | |
| G04 | 00 | Dwell, Exact stop | |
| G10 | 00 | Data setting | |
| G11 | 00 | Data setting mode cancel | |
| G12.1 | 25 | Polar coordinate interpolation mode | |
| G13.1 | 25 | + | Polar coordinate interpolation cancel mode |
| G17 | 02 | + | XpYp plane selection (Xp: X axis or its parallel axis) |
| G18 | 02 | ZpXp plane selection (Yp: Y axis or its parallel axis) | |
| G19 | 02 | YpZp plane selection (Zp: Z axis or its parallel axis) | |
| G20 | 06 | Input in inch | |
| G21 | 06 | Input in mm | |
| G27 | 00 | Reference position return check | |
| G28 | 00 | Return to reference position | |
| G29 | 00 | Return from reference position | |
| G30 | 00 | 2nd and 3rd reference position return | |
| G31 | 00 | Skip function | |
| G43 | 08 | Tool length compensation + direction | |
| G44 | 08 | Tool length compensation – direction | |
| G49 | 08 | + | Tool length compensation cancel |
| G65 | 00 | Macro call | |
| G66 | 12 | Macro modal call | |
| G67 | 12 | + | Macro modal call cancel |
| G73 | 09 | Peck drilling cycle | |
| G74 | 09 | Counter tapping cycle | |
| G76 | 09 | Fine boring | |
| G78 | 09 | Rigid normal threading cycle for chaser | |
| G79 | 09 | Rigid reverse threading cycle for chaser | |
| G80 | 09 | + | Canned cycle cancel |
| G81 | 09 | Drilling cycle, spot boring | |
| G82 | 09 | Drilling cycle, counter boring | |
| G83 | 09 | Peck drilling cycle | |
| G84 | 09 | Tapping cycle | |
| G85 | 09 | Boring cycle | |
| G86 | 09 | Boring cycle | |
| G87 | 09 | Back boring cycle | |
| G88 | 09 | Boring cycle | |
| G89 | 09 | Boring cycle | |
| G90 | 03 | + | Absolute command |
| G91 | 03 | + | Increment command |
| G92 | 00 | Setting for work coordinate system | |
| G93 | 05 | Rate feed | |
| G94 | 05 | + | Feed per minute |
| G95 | 05 | Feed per rotation |